General Discussion Archives

slab rift sawn white oak ply for cabinet doors
November 9, 2024

Hi there, I'm working on building some cabinets out of rift sawn WO plywood (grade A1). Question I have is do you think the doors will warp if I just use…
Suggestions for Hardie Cement Board rabbit cut
November 9, 2024

I need to make a rabbit cut into Hardie fiber cement lap siding to replace some old cedar installed vertically. The cut is 1/4" x 1/4". I have routers (full-size…
Magazine Archive
November 8, 2024

I bought a FW archive USB stick a while back, and I am trying to figure out how to access it. I am not sure which file has the…
Too many emails!
November 8, 2024

Today I got 12 emails about Issue #314! They came in every 3-4 minutes, same email, same message! Very annoying! I hope they can correct this issue since it happened…
General 350 Table Saw Blade Alignment
November 8, 2024

Hi,I recently purchased a used General 350 table saw and discovered saw blade was not aligned with the miter slot. I loosened all the bolts and kept one snug and…
Tips for those lacking courage?
November 7, 2024

I'm reaching a critical phase on a build that's been in the works for a long time. I've iterated the design many times, some of the key parts are roughed…
replacement Porter-Cable router 690, Type 5 base housing
November 4, 2024

I own a Porter-Cable 90690 router. Unfortunately, the router dropped out of the base under a router table and carved up the inside of the base. I own a brand-new…
Parts for a hole saw?
November 4, 2024

Where can I get parts for a hole saw? I got mine from a yard sale and there is no indicator as to who made it. Now I need the…
undermount drawer glides
November 4, 2024

Hi everyone,I need some information on undermount drawer glides. I'm coming to you, the more skilled and knowledgeable for answers. My project is a blanket chest on a stand with a…
3D Printing in Support of Woodworking
November 4, 2024

I would like to direct my question and comments to Ben.I would have liked liked very much to attend the recent conference in Iowa. For numerous reasons, I was not…

Page 1 of 2280

1
2
3
2280

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.

General Discussion Archives

Get the latest from Fine Woodworking Magazine

#314-Tools & Shops 2025

#313-NOV/DEC 2024

#312-SEPT/OCT 2024

#311-JULY/AUG 2024

#310-MAY/JUN 2024

We hope you’ve enjoyed your free articles. To keep reading, become a member today.